There are 3 possible ways to change batteries on SECURAM Safe Entrypads depending upon the Entrypad you have:
1. SureLock Drawer
On the lower right-hand side of the Entrypad, there will be a SureLock Drawer. Unlatch the lever by pulling it down. Remove the battery compartment.
Replace battery, reinsert the compartment and close the lever.
2. TopLit
Place palm over the face of the Entrypad, grasping the outer ring, and turn the ring counter clockwise (to the left) about a quarter of an inch. The ring will lift off the face of the Entrypad. The battery will be tucked in the lower side of the Entrypad housing.
3. Non-SureLock
Place your palm at the bottom of the Entrypad and push up about a quarter of an inch. The battery will be in the back of the Entrypad.
After replacing the battery, be sure to secure the wires and ribbon cables so that they are not pinched when replacing the Entrypad on the door. To replace, set the Entrypad on the shoulder screws and pull it down a quarter of an inch.
4. Xtreme
Xtreme Battery is located under the Entrypad. Be Sure to release the locking screw at the bottom of the entrypad.
5. Direct Drive
Direct Drive battery is located under the entrypad that sits on the dial ring. The entrypad attaches magnetically on the dial ring.
Comments
0 comments
Please sign in to leave a comment.